Suppressing substrate oxidation during plasma-enhanced atomic layer deposition on semiconductor surfaces

Plasma-enhanced atomic layer deposition (PE-ALD) is widely employed in microelectronics, energy, and sensing applications. Typically, PE-ALD processes for metal oxides utilize remote inductively coupled plasmas operated at powers of >200 W, ensuring a sufficient flux of oxygen radicals to the growth surface. However, this approach often leads to significant oxidation of chemically sensitive substrates, including most technological semiconductors. Here, we demonstrate that plasma powers as low as 5 W can effectively suppress substrate oxidation while maintaining the structural, optical, and electronic quality of the films. Specifically, we investigate the growth of titanium oxide (TiO_x) using two commonly used metalorganic precursors, titanium isopropoxide and tetrakis(dimethylamino)titanium. Films deposited with 5 and 300 W oxygen plasma power are nearly indiscernible from one another, exhibiting significantly lower defect concentrations than those obtained from thermal ALD with H₂O. The low plasma power process preserves desired physical characteristics of PE-ALD films, including large optical constants (n > 2.45 at 589 nm), negligible defect-induced sub-bandgap optical absorption (α < 10² cm⁻¹), and high electrical resistivity (>10⁵ Ω cm). Similar behavior, including suppressed interface oxidation and low defect content, is observed on both Si and InP substrates. As an example application of this approach, the assessment of InP/TiO_x photocathodes and Si/TiO_x photoanodes reveals a significant improvement in the photocurrent onset potential in both cases, enabled by suppressed substrate oxidation during low power PE-ALD. Overall, low power PE-ALD represents a generally applicable strategy for producing high quality metal oxide thin films while minimizing detrimental substrate reactions.