Evaluation of long-term stability of monolithic 3D-printed robotic manipulator structures for minimally invasive surgery

Purpose: In the era of patient-centered medicine, clinical procedures, tools and instruments should be individually adapted to the patient. In this context, the presented 3D-printed Single-Port Overtube Manipulator System follows the aims to provide patient- and task-specific disposable manipulators for minimally invasive surgery. In a first experiment, the robustness of the monolithic flexure hinge structures in use as robotic manipulators will be investigated. Methods: Customizable monolithic manipulator structures designed by means of an automated design process and manufactured with selective laser sintering were investigated with regard to long-term stability in an endurance test. Therefore, a bare manipulator arm, an arm equipped with a standard instrument and finally loaded with an additional load of 0.5 N were evaluated by continuously following a trajectory within the workspace of the manipulator arms over a period of 90 min. Results: The unloaded manipulator as well as the manipulator arm equipped with a standard instrument showed a sufficient reproducibility (deviation of 1.5 mm and 2.5 mm, respectively, on average) with regard to an application as telemanipulated master–slave surgical robotic system. The 3D-printed manipulators showed no damage and maintained integrity after the experiment. Conclusion: It has been shown that 3D-printed manipulators in principle are suitable for use as disposable surgical manipulator systems and offer a long-term stability over at least 90 min. The developed manipulator design shows great potential for the production of patient-, task- and user-specific robot systems. However, the manipulator geometries as well as the control strategies still show room for improvements.